pa2a.org


Share Thread:  
[Offering Services] Gunsmithing/Transfers Central PA
#1
Getting back up and running on the forum (been absent for a while).

I am a 01 FFL located just outside State College. I mainly do gun repairs and restorations but I also do low cost transfers (sliding scale $20 for 1 gun, $35 for 2, $45 for 3, $12.50 each for 4 or more at the same time)

I also do Cerakoting, a very corrosion and wear resistant coating.

Any questions just let me know via PM or email (rlutz730 (at) comcast.net)
Xringshooter, proud to be a member of pa2a.org since Sep 2012.
Reply
#2
Good to see some people in my area. I'll keep you in mind.

Do any AK work? Looking to cut a barrel down to 5-6 inches.
[Image: picsay-1358258813.jpg]
Reply
#3
Mr_Gixxer;156248 Wrote:Good to see some people in my area. I'll keep you in mind.

Do any AK work? Looking to cut a barrel down to 5-6 inches.

Are you looking to make an SBR? What else do you want to do the barrel after shortening it? Best would be to PM me or send me an email to discuss this.
Xringshooter, proud to be a member of pa2a.org since Sep 2012.
Reply
#4
Xringshooter;156257 Wrote:
Mr_Gixxer;156248 Wrote:Good to see some people in my area. I'll keep you in mind.

Do any AK work? Looking to cut a barrel down to 5-6 inches.

Are you looking to make an SBR? What else do you want to do the barrel after shortening it? Best would be to PM me or send me an email to discuss this.

PM sent. Thanks!
[Image: picsay-1358258813.jpg]
Reply
#5
Well, I am retiring from my full time job effective March 12, 2015 so by the end of March I will be expanding my gun shop/gunsmithing hours into the day time with evening hours by appointment only. Probably willl be open Tuesday-Saturday just don't kniow what hours yet. I will post again when everything is finalized.
Xringshooter, proud to be a member of pa2a.org since Sep 2012.
Reply








Users browsing this thread: 1 Guest(s)

Software by MyBB, © 2002-2015 MyBB Group.
Template by Modogodo Design.